View Single Post
  #10  
Old 07-08-2012, 11:02 PM
Special.K Special.K is offline
Registered User
 
Join Date: Nov 2005
Location: Castlemaine, Victoria, Australia
Posts: 631
Quote:
Originally Posted by herbalpudding
The interesting challenge with this setup is managing the depth of the items on the top 10RU spaces. If they are too deep, they will touch the items in the bottom 4RU spaces and not fit. For example, this is why the isolator is on the front panel and the mixer sits above the expander rather than below it.

This is one reason why i now use a Effect Rack Case as it is 10inch deep front to back and i just sit it on it's back lid and drilled some holes each side for the cables! i actually welded up a frame to hold the case on a angle but i worked out i don''t mind it being flat!
Reply With Quote